Philips VRA211AT Removing the Plastic Cover from the Front Panel, Using the Remote Control

Models: VRA211AT

1 44
Download 44 pages 22.79 Kb
Page 5
Image 5

Removing the Plastic Cover from the Front Panel

A thin, plastic cover may protect the front panel of your VCR. Before using the VCR, lift a corner of the plastic, then peel it off.

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding it in the direction of the arrow.

2

Place two AA batteries inside the battery compartment

with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Using the Remote Control

Point the remote control at the VCR, then press the VCR but- ton, when using the remote control to operate the VCR.

If you have a Magnavox, Philips, or Philips Magnavox television, point the remote control at the TV, then press the TV button, when using the remote control to operate the TV.

Before Using Your VCR 5

1

2 3

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.

1

To prevent erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

VCR maintenance

Use only tapes with the mark.

Remove any light adhesive stick-on notes from the video cas- sette tape before putting the tape in the VCR. Removable labels can jam the VCR.

Periodic maintenance is required to maintain your VCR’s excel- lent performance. This VCR has an Automatic Head Cleaner. However, the video heads will require replacement eventually. Only an authorized service center should perform this service.

1

2

Helpful Hints

Do not mix alkaline and man- ganese batteries.

Do not mix old and new batteries.

Page 5
Image 5
Philips VRA211AT Removing the Plastic Cover from the Front Panel, Putting Batteries in the Remote Control, VCR maintenance