Phonetics 5000, 5100 manual Differences Between Standard C and Isacc C

Chapter 8: C Programming

DIFFERENCES BETWEEN STANDARD C AND ISACC C

For those of you who are familiar with C programming, note that there are some differences between standard C and ISACC’s C compiler. The following items will be helpful to be aware of:

1.With ISACC C, every IF, ELSE, FOR, DO, and WHILE must have a set of brackets {} after it.

2.Condition clauses must be grouped together into pairs.

Standard C will allow:

IF ((condition1) && (condition2) && (condition3))

ISACC C requires:

IF (((condition1) && (condition2)) && (condition3))

3.There are no shortcut statements such as:

i++; red+=5; or bits&=5;

However, statements such as the following are allowed if placed inside parentheses:

IF ( (x=input(5)) ==0)

4.Bitwise operators are not implemented. There are no:

bitmask = bitmask & 4;

5.ISACC C only works with base ten integers. No floating point or hexadecimal numbers can be used unless you implement them in your C program. However, doing so takes up the limited code space. Remember, you only have 8k of listing space, and 2k of compiled space.

6.Variables declared before the main statement retain their values after the program has been executed. This provides the programmer with nonvolatile memory between runs of the program. This is useful for accumulating, timing, and most ISACC appli- cations.

7.There are no user defined functions or procedures.

8.The run through, don't loop if you can avoid it philosophy.

Avoid the use of WHILE loops. This will lengthen the execution and response time of your C program, and serves no advantage. Write your programs such that they run straight through and exit. If your program is checking for a certain condition to occur, using a WHILE loop will cause your program to concentrate on that one condition unnecessarily. Since the program will execute at regular time intervals, you can use an IF statement and achieve the same or even better results. For example, we need a program to perform two independent tasks. The first task is to set output 9 on for 60 seconds whenever input 1 closes. The second task is to change the datalogger rate to once per second upon closure of input 2.

107