Phonetics 5000, 5100 NOTE: The unit will not speak the input name when in voice mode.

58
Sensaphone® ISACC Instruction Manual
IN14 is now Digital: N.O. Name = "Input #14 "
IN15 is now Digital: N.O. Name = "Input #15 "
IN16 is now Digital: N.O. Name = "Input #16 "
To configure the input type and assign a descriptive name, type set itype after an ISACC
prompt. Enter the type number to change the input type and press ENTER to get to the
name parameter. Enter an input name. The name may be up to 16 characters. Press ENTER
to go to the next input. You may prog ram a specific itype by typing set itype followed by the
input number.
ISACC>set itype
INPUT TYPE
00 = Digital: N.C. 01 = Digital: N.O. 02 = Digital: P.C.
03 = Analog: 4-20mA 04 = Analog: 0-5 Volts 05 = Analog: 2.8K F
06 = Analog: 2.8K C 07 = Analog: 10K F 08 = Analog: 10K C
09 = Analog: Table 1 10 = Analog: Table 2 11 = Analog: Table 3
12 = Analog: Table 4 13 = User Defined
IN01 is now Digital: N.O. >00 Name = "Input #1 " >LOW WELL FLOAT
IN02 is now Digital: N.O. > Name = "Input #2 " >HI SUMP FLOAT
IN03 is now Digital: N.O. > Name = "Input #3 " >
IN04 is now Digital: N.O. >09 Name = "Input #4 " >FLOW RATE(GPM)
IN05 is now Digital: N.O. >10 Name = "Input #5 " >WELL LEVEL(FT)
IN06 is now Digital: N.O. > Name = "Input #6 " >RESET
IN07 is now Digital: N.O. > Name = "Input #7 " >
IN08 is now Digital: N.O. >09 Name = "Input #8 " >VOLTAGE
IN09 is now Digital: N.O. > Name = "Input #9 " >
IN10 is now Digital: N.O. > Name = "Input #10 " >
IN11 is now Digital: N.O. > Name = "Input #11 " >
IN12 is now Digital: N.O. > Name = "Input #12 " >
IN13 is now Digital: N.O. > Name = "Input #13 " >
IN14 is now Digital: N.O. > Name = "Input #14 " >
IN15 is now Digital: N.O. > Name = "Input #15 " >
IN16 is now Digital: N.O. > Name = "Input #16 " >
NOTE: The unit will not speak the input name when in voice mode.