Pioneer AVH-P4050DVD Setting the rear output and subwoofer controller, Operating this unit

	Section
Operating this unit	03

%Touch AM STEP on the initial menu to select the AM tuning step.

Touching AM STEP will switch the AM tuning step between 9 kHz and 10 kHz. The selected AM tuning step will appear in the display.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (FULL) or subwoofer (S.W) con- nection. If you switch the rear output setting to S.W, you can connect a rear speaker lead directly to a subwoofer without using an auxili- ary amp.

Initially, the unit is set for rear full-range speak- er connection (FULL). When rear output is connected to full range speakers (when FULL is selected), you can connect other full range speakers (REAR) or a subwoofer (S.W) to the RCA rear output.

!When the multi-channel processor (e.g., DEQ-P7650) is connected to this unit, you cannot operate this function.

1Touch REAR SP on the initial menu.

2Touch c or d next to REAR SP to switch the rear output setting.

Touch c to select full-range speaker and FULL appears in the display. Touch d to select sub-

woofer and S.W appears in the display.

# When no subwoofer is connected to the rear

output, select FULL (full-range speaker).

# When a subwoofer is connected to the rear

output, select S.W (subwoofer).

# When the rear output setting is S.W, you can- not operate the following procedure.

3Touch c or d next to PREOUT to switch the subwoofer output or rear output. Touching cor d will switch between S.W and REAR and that status will be displayed.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 36).

!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.

!Both rear speaker lead outputs and RCA rear output are switched simultaneously in this setting.

Switching the sound muting/ attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

%Touch TEL to select any of the muting, attenuation or off.

Touch TEL until the desired setting appears in the display.

!MUTE – Muting

!ATT -20dB – Attenuation (ATT -20dB has a stronger effect than ATT -10dB)

!ATT -10dB – Attenuation

!OFF – Turn the sound muting/attenuation off

Notes

!The sound is turned off, MUTE is displayed and no audio adjustments are possible.

!The sound is attenuated, ATT is displayed and no audio adjustments, except volume control, are possible.

!Operation returns to normal when the phone connection is ended.

Operating this unit

En 43