Pioneer AVH-P4050DVD operation manual Using the auto-equalizer, 04Available accessories

Section

04Available accessories

LOW (low)—MID (mid)—HIGH (high)

7Touch b and then touch c or d to se- lect the center frequency of selected band. Touch c or d until the desired frequency ap- pears in the display. 40Hz—50Hz—63Hz—80Hz—100Hz—125Hz

—160Hz—200Hz—250Hz—315Hz—400Hz— 500Hz—630Hz—800Hz—1kHz—1.25kHz— 1.6kHz—2kHz—2.5kHz—3.15kHz—4kHz— 5kHz—6.3kHz—8kHz—10kHz—12.5kHz

8Touch b and then touch c or d to ad- just the equalizer level.

Each time you touch cor d it increases or de- creases the equalizer level. +12 to –12 is dis- played as the level is increased or decreased.

9Touch b and then touch c or d to se- lect the desired Q factor.

Each time you touch cor d switches between the following Q factor:

NARROW (narrow)—WIDE (wide)

# You can adjust parameters for each band of the other speakers in the same way.

Note

You can select a center frequency for each band. You can change the center frequency in 1/3-oc- tave steps, but you cannot select frequencies that have intervals shorter than 1 octave among the center frequencies of the three bands.

Using the auto-equalizer

The auto-equalizer is the equalizer curve cre- ated by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on this page).

You can turn the auto-equalizer on or off.

1Touch NEXT twice on the DSP function menu.

2Touch AUTO EQ.

#You cannot use this function if auto TA and EQ has not been carried out.

3Touch d to turn the auto-equalizer on.

# To turn auto-equalizer off, touch c.

Auto TA and EQ (auto-time alignment and auto-equalizing)

The auto-time alignment is automatically ad- justed for the distance between each speaker and the listening position.

The auto-equalizer automatically measures the car interior acoustic characteristics, and then creates the auto-equalizer curve based on that information.

WARNING

To prevent accidents, never carry out auto TA and EQ while driving. When this function measures the car interior acoustic characteristics to create an auto-equalizer curve, a loud measurement tone (noise) may be outputted from the speakers.

CAUTION

!Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly be- fore carrying out auto TA and EQ.

—When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.)

—When a speaker is connected to a power amp delivering output higher than the speaker’s maximum input power capabil- ity.

!If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in a drain on battery power. Be sure to place the microphone in the specified loca- tion.

74 En