Pioneer AVH-P6400 Installation, DIN Front/Rear-mount, DIN Front-mount, Remove the frame. Fig

Installation

Note:

•Before finally installing the unit, connect the wiring temporarily, making sure it is all connect- ed up properly, and the unit and the system work properly.

•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

•Consult with your nearest dealer if installation requires the drilling of holes or other modifica- tions of the vehicle.

•Install the unit where it does not get in the dri- ver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

•Do not place the display in a position where it will impede the driver’s visibility or affect the operation of your vehicle’s air bags.

•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot

— for instance, near a heater outlet.

•If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. (Fig. 8)

30°

Fig. 8

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush

1. Remove the frame. (Fig. 9)

Frame

Pull out to remove the frame.

(When reattaching the frame, point the side with a groove downwards and attach it.)

Fig. 9

9