settings for the speaker over which you hear
the test tone are shown in the display.
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
#Check each speaker output level. If no adjust-
ments are needed, perform step 4 to stop the test
tone.
#The settings do not appear for speakers
whose size is set OFF.
3 Pressqorrtoadjustthespeaker
outputlevel.
Each press of qor rincreases or de-
creases the speaker output level. +10 10is
displayed as the level is increased or de-
creased.
#The test tone rotates to the next speaker after
about two seconds from the last operation.
4 Pressmtostopthetesttoneoutput.
5 PressBANDtoreturn totheplayback
display.
Notes
!If needed, select speakers and adjust their ab-
soluteoutput levels. (Refer to Adjusting the
speaker output levels on the previous page.)
!To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at SPLev. Both provide the same re-
sults.

Using the time alignment

The time alignment lets you adjust the dis-
tance between each speaker and the listening
position.
1 Presspandholduntil SPSetappears
inthedisplay,thenpressptoselect
TAMODE.
2 Pressmorntoselectthetime
alignment.
!INITInitial time alignment (factory set-
ting)
!CUSTOMAdjusted time alignment that
you can create for yourself
!AUTOTATime alignment created by auto
TA and EQ. (Refer to Auto TA and EQ (auto-
time alignment and auto-equalizing) on the
next page.)
!OFFTurn the time alignment off
#To turn time alignment off, select TA:OFF.
#You cannot select AUTOTAif auto TA and EQ
has not been carried out.
#You cannot select ADJUSTMENTwhen
neither F/Lnor F/Ris selected in Posi.
3 PressBANDtocancel thetimealign-
mentmode.

Adjusting the time alignment

By adjusting the distance between each
speaker and a selected listening position, you
can insert delay times into the speaker output
to obtain a correct sound image and overall
level balance. Although this is automatically
achieved when you set the listening position,
the time alignment feature provides a fine ad-
justment.
1 Presspandholduntil SPSetappears
inthedisplay,thenpressptoselect
TimeA.
After SPSetis displayed, press puntil
TimeAappears in the display.
#You cannot select TimeAwhen neither F/L
nor F/Ris selected in Posi.
Digital Signal Processor
En 27
English
Section
07