Troubleshooting
Common
Symptom Cause Action (See)
Power doesnt turn on.
The unit doesnt operate.
Leads and connectors are incor-
rectly connected.
Confirm once more that all connections are
correct.
The fuse is blown. Rectify the reason for the fuse blowing, then
replace the fuse. Be very sure to install the
correct fuse with the same rating.
Noise and other factors are causing
the built-in microprocessor to oper-
ate incorrectly.
Turn the unit off and then on.
Operation with the remote con-
trol isnt possible.
The unit does not operate cor-
rectly even when the appropriate
remote control buttons are
pressed.
The remote control operation mode
is incorrect.
Switch to the correct remote control mode.
(Page 6)
The remote control code is incor-
rect.
Make sure the remote control selection
switch setting and code type setting are the
same. (Page 37)
Battery power is low. Load new battery. (Page 5)
No sounds are heard.
The volume level will not rise.
Cables are not connected correctly. Connect the cables correctly.
There is no sound.
Volume level is low.
The volume level is low. Adjust the volume level.
The attenuator is on. Turn the attenuator off.
Error messages
When problems occur with disc playback, an error message appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest PIONEER Service Center.
Error messages
Message Cause Action (See)
ERROR-02 Dirty disc Clean disc.
Scratched disc Replace disc.
TEMP The temperature of this unit is out-
side the normal operating range
Wait until the units temperature returns to
within normal operating limits.
ERROR-10 The disc does not have the same re-
gion number as this unit
Replace the DVD video with one bearing the
correct region number.
NONPLAY This type of disc cannot be played
by this unit
Replace the disc with one this unit can play.
The disc is loaded upside down Check that the disc is loaded correctly.
Additional Information
En 39
English
Appendix