Pioneer DEH-P760MP Switching the dimmer setting, Adjusting the brightness, Setting the rear output and subwoofer controller

1 PressFUNCTION to select AUX.
PressFUNCTION repeatedly until AUX ap-
pearsin the display.
2 Pressaor bto turn AUX on or off.
Pressingaor bwill turn AUX on or off and
thatstatus will be displayed (e.g.,
AUX:ON).
Switching the dimmer setting
Toprevent the display from being too bright at
night,the display is automatically dimmed
whenthe car s headlights are turned on. You
canturn dimmer on or off.
1 PressFUNCTION to select Dimmer.
PressFUNCTION repeatedly until Dimmer ap-
pearsin the display.
2 Pressaor bto turn Dimmer on or off.
Pressingaor bwill turn Dimmer on or off
andthat status will be displayed (e.g.,
Dimmer:ON).
Adjusting the brightness
Youcan adjust the display brightness. Initially
thismode is set to 12.
1 PressFUNCTION to select Brightness.
PressFUNCTION repeatedly until Brightness
appearsin the display.
2 Presscor dto adjust the brightness
level.
Eachpress of cor dincreases or decreases
thebrightness level. 015 is displayed as the
levelis increased or decreased.
Setting the rear output and
subwoofer controller
Thisunits rear output (rear speaker leads out-
putand RCA rear output) can be used for full-
rangespeaker (REAR SP:FULL) or subwoofer
(REARSP :S/W) connection. If you switch the
rearoutput setting to the REAR SP:S/W, you
canconnect a rear speaker lead directly to a
subwooferwithout using an auxiliar y amp.
Initially,the unit is set for rear full-range speak-
erconnection (REAR SP:FULL). When rear
outputare connected to full range speakers
(whenREAR SP:FULL is selected), you can
connectthe RCA subwoofer output to a sub-
woofer.In this case, you can select whether to
usethe subwoofer controller s (low pass filter,
phase)built-in PREOUT :S/W or the auxiliary
PREOUT:FULL.
1 PressFUNCTION to select REAR SP.
PressFUNCTION repeatedly until REAR SP ap-
pearsin the display.
2 Pressaor bto switch the rear output
setting.
Pressingaor bwill switch between
REARSP :FULL (full-rangespeaker) and
REARSP :S/W (subwoofer)and that status will
bedisplayed.
#Whenno subwoofer is connected to the rear
output,select REAR SP:FULL.
#Whena subwoofer is connected to the rear
output,set for subwoofer REAR SP:S/W.
#Whenthe rear output setting is
REARSP :S/W, you cannot change the subwoofer
controller.
3 Presscor dto switch the subwoofer
outputor non fading output (full-range
RCAoutput).
Pressingcor dwill switch between
PREOUT:S/W and PREOUT:FULL and that
statuswill be displayed.
Initial Settings
En 43
English
Section
09