Section
07Audio Adjustments
Using no fading output
When the non fading output setting is on, the audio signal does not pass through this unit’s low pass filter (for the subwoofer), but is output through the RCA output.
1Press OPEN to open the front panel.
2Press AUDIO to select non fading output on/off mode.
When the subwoofer controller setting is S.W Control:EXT, you can select non fading output on/off mode. Press AUDIO until NonFad ON appears in the display.
3Press 5 to turn non fading output on.
NonFad ON appears in the display. non fading output is now on.
• You can turn off non fading output by pressing
∞.
Adjusting non fading output level
When the non fading output is on, you can adjust the level of non fading output.
1Press OPEN to open the front panel.
2Press AUDIO to select non fading output setting mode.
Press AUDIO until NonFad 0 appears in the dis- play.
3Press 5 or ∞ to adjust the output level of the non fading.
Each press of 5 or ∞ increases or decreases the level of the non fading. +6 –
Press 5 or ∞ until you see the desired value displayed. 
Using the high pass filter
When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, switch the HPF (high pass filter) on. Only frequencies higher than those in the selected range are output from the front and rear speakers.
1Press OPEN to open the front panel.
2Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
3Press 5 to turn high pass filter on. HPF 80 Hz appears in the display. High pass filter is now on.
• To turn high pass filter off, press ∞.
4Press 2 or 3 to select a high pass filter range.
Press 2 or 3 until the desired
• Only frequencies higher than those in the selected range are output from the front or rear speakers.
Note
•If you switch the SFEQ mode, the H.P.F. func- tion is automatically switched off. By switch- ing the H.P.F. function on after selecting the SFEQ mode, you can combine H.P.F. function with SFEQ function. 
42En
