Theexclamation point within an equilateral
triangleis intended to alert the user to the
presenceof important operating and
maintenance(servicing) instructions in the
literatureaccompanying the appliance.
Thelightning flash with arrowhead symbol,
withinan equilateral triangle, is intended to
alertthe user to the presence of uninsulated
"dangerousvoltage" within the product's
enclosurethat may be of sufficient
magnitudeto constitute a risk of electric
shockto persons.
CAUTION:
TOPREVENT THE RISK OF ELECTRIC
SHOCK,DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICEPERSONNEL.
CAUTION
RISKOF ELECTRIC SHOCK
DONOT OPEN
IMPORTANT
D3-4-2-1-1_En-A
Replacementand mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
servicepersonnel.
D3-4-2-1-2-2_B_En
IMPORTANT:THE MOULDED PLUG
Thisappliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. Should the
fuseneed to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTAor BSI to BS1362.
Checkfor the ASTAmark orthe BSI mark onthe body of the fuse.
Ifthe plug contains a removable fuse cover,you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
mustnot be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
Ifthe fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely.There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
Ifa new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
IMPORTANT:Thewires in this mains lead are coloured in accordance with the following code:
Blue: Neutral Brown: Live
Asthe colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
yourplug, proceed as follows ;
Thewire which is coloured BLUE must be connected to the terminal which is marked with the
letterNor coloured BLACK.
Thewire which is coloured BROWN must be connected to the terminal which is marked with the
letterLor coloured RED.
Howto replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
aresidential installation. Thisequipmentgenerates, uses, and can radiate radio frequency energy and, ifnot
installedand used in accordance with the instructions, may cause harmful interference to radio communications.
However,there is no guarantee that interference will not occur in a particular installation. If this equipment does
causeharmful interference to radio or television reception, which can be determined by turning the equipment off
andon, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorientor relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
D8-10-1-2_En
CAUTION:This product satisfies FCC regulations when shielded cables and connectors are used to connect the
unitto other equipment. To prevent electromagnetic interference with electric appliances such as radios and
televisions,use shielded cables and connectors for connections.
D8-10-3a_En
Informationto User
Alterationor modifications carried out without
appropriateauthorization may invalidate the user’s
rightto operate the equipment.
D8-10-2_En
Ifthe AC plug of this unit does not match the AC
outletyou want to use, the plug must be removed
andappropriate one fitted. Replacement and
mountingof an AC plug on the power supply cord of
thisunit should be performed only by qualified
servicepersonnel. If connected to an AC outlet, the
cut-offplug can cause severe electrical shock. Make
sureit is properly disposed of after removal.
Theequipment should be disconnected by removing
themains plug from the wall socket when left
unusedfor a long period of time (for example, when
onvacation). D3-4-2-2-1a_A_En
CAUTION
ThePOWER switch on this unit will not completely
shutoff all power from the AC outlet. Since the
powercord serves as the main disconnect device for
theunit, you will need to unplug it from the AC outlet
toshut down all power. Therefore, make sure the
unithas been installed so that the power cord can
beeasily unplugged from the AC outlet in case of an
accident.To avoid fire hazard, the power cord should
alsobe unplugged from the AC outlet when left
unusedfor a long period of time (for example, when
onvacation). D3-4-2-2-2a_A_En
WARNING
Thisequipment is not waterproof. To prevent a fire
orshock hazard, do not place any container filed
withliquid near this equipment (such as a vase or
flowerpot) or expose it to dripping, splashing, rain
ormoisture. D3-4-2-1-3_A_En
WARNING
To prevent a fire hazard, do not place any naked
flamesources (such as a lighted candle) on the
equipment. D3-4-2-1-7a_A_En
VENTILATIONCAUTION
Wheninstalling this unit, make sure to leave space
aroundthe unit for ventilation to improve heat
radiation(at least 5 cm at rear, and 3 cm at each
side).
WARNING
Slotsand openings in the cabinet are provided for
ventilationto ensure reliable operation of the
product,and to protect it from overheating. To
preventfire hazard, the openings should never be
blockedor covered with items (such as newspapers,
table-cloths,curtains) or by operating the
equipmenton thick carpet or a bed.
D3-4-2-1-7b_A_En
OperatingEnvironment
Operatingenvironment temperature and humidity:
+5ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH
(coolingvents not blocked)
Donot install this unit in a poorly ventilated area, or in
locationsexposed to high humidity or direct sunlight (or
strongartificial light) D3-4-2-1-7c_A_En
WARNING
Thevoltage of the available power supply differs
accordingto country or region. Be sure that the
powersupply voltage of the area where this unit
willbe used meets the required voltage (e.g., 230V
or120V) written on the bottom panel.
D3-4-2-1-4_A_En
mod
Beforeplugging in for the first time, read the following
sectioncarefully.
POWER-CORDCAUTION
Handlethe power cord by the plug. Do not pull out the
plugby tugging the cord and never touch the power
cordwhen your hands are wet as this could cause a
shortcircuit or electric shock. Do not place the unit, a
pieceof furniture, etc., on the power cord, or pinch the
cord.Never make a knot in the cord or tie it with other
cords.The power cords should be routed such that they
arenot likely to be stepped on. A damaged power cord
cancause a fire or give you an electrical shock. Check
thepower cord once in a while. When you find it
damaged,ask your nearest PIONEER authorized
servicecenter or your dealer for a replacement. S002_En
Thankyou for buying this Pioneer product.
Pleaseread through these operating instructions so you will know how to operate your model properly. After you have finished reading
theinstructions, put them away in a safe place for future reference.
In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory
drawings.However the method of connecting and operating the unit is the same. K015En
Whenusing this product follow the instructions
writtenon the underside of the unit, which
concernrated voltage, etc.
D3-4-2-2-4_En
01_DJM-700_En.book 2 ページ ２００７年７月１１日　水曜日　午後１時５１分