Pioneer DJM-850-K, DJM-850-S, DJM-850-W Click the [ASIO] tab, Click the [About] tab, 1 Click the [MIXER OUTPUT] tab, 3Click the [USB Output Level] pull-downmenu

Setting the audio data output from this unit to the computer

Display the setting utility before starting.

1 Click the [MIXER OUTPUT] tab.

Click the [ASIO] tab.

English

!If the buffer size is made large, drops in audio data (breaks in the sound) occur less easily, but the time lag due to the delay in the transfer of the audio data (latency) increases.

2 Click the [Mixer Audio Output] pull-down menu.

Select and set the audio data to be output to the computer from the flow of audio signals inside this unit.

CH1	CH2	CH3	CH4
CH1 Timecode	CH2 Timecode	CH3 Timecode	CH4 Timecode
PHONO1	CD/LINE1	CD/LINE1	PHONO1
CH1 Timecode	CH2 Timecode	CH3 Timecode	CH4 Timecode
CD/LINE1	LINE1	LINE1	CD/LINE1
Post CH1 Fader2	Post CH2 Fader2	Post CH3 Fader2	Post CH4 Fader2
Cross Fader A2	Cross Fader A2	Cross Fader A2	Cross Fader A2
Cross Fader B2	Cross Fader B2	Cross Fader B2	Cross Fader B2
MIC	MIC	MIC	MIC
REC OUT2	REC OUT2	REC OUT2	REC OUT2
None	None	None	None

1The audio data is output with the same volume at which it is input to this unit, regardless of the [USB Output Level] setting.

2When using for any purposes other than sound recording, pay attention to set the DJ software so that sound loops are not generated. If sound loops are gener- ated, sound with an unintended volume might be input or output.

3Click the [USB Output Level] pull-down menu.

Adjust the volume of the audio data output from this unit.

!The [USB Output Level] setting is applied equally to all audio data. However, when 1 on the table at step 2 is selected, the audio data is output with the same volume at which it is input to this unit.

!If not enough volume can be achieved with the DJ software’s volume adjustment alone, change the [USB Output Level] setting to adjust the volume of the audio data output from this unit. Note that the sound will be distorted if the volume is raised too high.

Adjusting the buffer size (when using Windows ASIO)

If an application using this unit as the default audio device (DJ software, etc.) is running, quit that application before adjusting the buffer size. Display the setting utility before starting.

Checking the version of the driver software

Display the setting utility before starting.

Click the [About] tab.Checking the latest information on the driver software

For the latest information on the driver software for exclusive use with this unit, visit our website shown below. http://pioneerdj.com/support/

!Operation cannot be guaranteed when multiple units of this mixer are connected to a single computer.

En 11