Pioneer DV-464, DV-360, DV-2650 operating instructions Connecting using the S-video output

Connecting up

1Connect the VIDEO OUT and AUDIO OUT L/R jacks to a set of A/V inputs on your TV.

Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound.

See below if you want to use a SCART cable for the audio/video connection, or an S-Video cable for the video connection.

2Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet.

•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel

STANDBY/ON button, or the remote control, and wait of the -OFF-message to disappear from the player’s display.

•For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers.

02

Connecting using the S-video output

If your TV (or other equipment) has an S-video input, you can use this instead of the stan- dard (composite) output for a better quality picture.

•Use an S-video cable (not supplied) to connect the S-VIDEO OUT to an S-video input on your TV (or monitor or AV receiver).

Line up the small triangle above the jack with the same mark on the plug before plugging in.

S-VIDEO

IN

TV

DIGITAL AUDIO OUT	AUDIO OUT
COAXIAL	L	AV CONNECTOR (RGB) - TV/AV Receiver

R

OPTICAL

S

VIDEO OUT

13

En