Pioneer DVD-V5000 Function Assignment, Interface Connector, EXTEND TERMINAL CONTROL, 1 To recall Barcode/Command Stacks and execute

11Additional information

Extend Terminal

To activate a function, create a switch contact with an electrical ground (Pin 1). Refer to page 71

“Interface Connector” to verify pin (Pin 6 through Pin 13) and terminal (SW1 – SW8) assignments. There are three (SW) functions in the EXTEND TERMINAL CONTROL.

1 To recall Barcode/Command Stacks and execute

The function, STACK GROUP 1 to STACK GROUP 27, is similar to a combination of remote control buttons to recall and execute a stack.

2 To execute the function as a remote control command

The function acts in the same manner as remote control the buttons (ENTER, PLAY, STOP, etc.) excluding SCAN FWD/REV.

When the remote control’s SCAN buttons (￿, ￿) are pressed and released, the scan operation continue, However, the SCAN FWD/SCAN REV keys on the Extend Terminal operate only while held down; the operation stops when the keys are released.

3 To execute as an advanced remote control button

Advanced remote control commands such as numbers from 10 to 20 may be sent as a switch control command.

Function Assignment

Create a Circuit Controller or a Diode Matrix Circuit (refer to the table below).

Diode Assignment List (Standard setting and User default setting)

	SW1	SW2	SW3	SW4	SW5	SW6	SW7	SW8
No.	￿	￿	￿	￿	ENTER	X	Y	Z	Function
1	X								￿
2		X							￿
3			X						￿
4				X					￿
5					X				ENTER
6						X			STACK GROUP1
7							X		STACK GROUP2
8								X	STACK GROUP3
9		X						X	10
10			X					X	11
11				X				X	12
12	X	X							OPEN/CLOSE
13			X	X					DISPLAY
14	X					X			1
15		X				X			2
16			X			X			3
17				X		X			4
18	X						X		5
19		X					X		6
20	X			X					￿
21		X		X					￿
22		X	X						￿
23	X		X						￿

68