Pioneer MEP-7000 Handling Discs And Other Media, English, To disconnect a USB storage device

Models: MEP-7000

1 206
Download 206 pages 60.68 Kb
Page 25
Image 25
Manual background

HANDLING DISCS AND OTHER MEDIA

Manual background CAUTION

Manual background Depending on the device used, proper playback may not be possible with all USB storage devices. Pioneer assumes no responsibility for any loss of data resulting from connecting any given USB device to this unit.

Proper operation may not be possible when a USB storage device is connected through a USB hub.

Even if a USB hub is used to connect multiple USB storage devices, the second and later devices cannot be used.

This unit may not operate properly due to insufficient power if it is connected to a bus-power type USB hub when another connected USB device draws heavy power consumption from the same hub.

Even if the USB storage device is connected directly to this unit, if excessive current is drawn by the device, power may be shut off, resulting in failure of data transmission (an error message will appear on the center display). Following the instructions in “To disconnect a USB storage device” (P. 25), disconnect the device. If data transmission is still not possible, try turning the power off and on again.

Operation cannot be guaranteed when using a USB storage device with installed flash card reader.

When connecting a USB storage device utilizing two USB cables, connect both cables to this unit’s USB ports.

To disconnect a USB storage device

1Hold the STOP button pressed for one second or more.

2Confirm that the indicator goes out.

Confirm on the front panel that the red indicator for the connected port has change from flashing to off.

3Disconnect the USB storage device.

Manual background MEMO

After the indicator goes out, if the STOP button is held depressed for two seconds or more, the USB storage device's connection can be reinitiated without the need to physically disconnect and reconnect it.

Manual background CAUTION

Manual background When disconnecting a USB storage device, always be sure to perform the STOP operation first.

If the STOP operation is not completed before disconnection, cue/loop memory and playlist update may not occur properly, resulting in the loss of data. Also, the USB storage device may becomes unreadable, or other substantial damage may occur.

In the case of a HDD device, do not subject it to impact or vibration during use.

Always disconnect the USB storage device before turning off the power to this unit.

English

25

En

Page 25
Image 25
Pioneer MEP-7000 operating instructions Handling Discs And Other Media, English, To disconnect a USB storage device