List of parts and equipment included
Be sure to check that all the parts and equipment listed below have been included before beginning to assemble your stand.
•Note that a Philips screwdriver (not included) is required for assembly.
• Center support column x1 | • Base x1 | • PDP bracket x1 |
• Glass panel x1 | • Glass stays | • Support column covers |
| (x2, one left and one right) | (x2, one left and one right) |
Caution
The glass panel should be kept in its packing box until you are ready to attach it to the stand to guard against breakage.
• Long support legs x2 | • Short support legs x2 | • Cable cover x1 | • Cap x1 |
|
| (for attachment to |
|
|
| support column) |
|
(Please refer to the table for Procedure 3 on page 11 for usage.)
• Short hexagonal bolts (M8 x 16 mm: black) x12 | • Hexagonal wrench x1 | • Cable clamps x4 |
| (Opposite side 6 mm for M8 use) |
|
• Middle hexagonal bolts (M8 x 35 mm: black) x4 | • Screws (M4 x 10 mm: silver) x4 |
• Long hexagonal bolts (M8 x 60 mm: silver) x2 | • Screws (M4 x 10 mm: black) x2 |
•Operating instructions (This document) x1
フローティングスタンド |
Floor stand |
Support de base |
Bodenständer |
Supporto per display |
Vloerstandaard |
Soporte para colocar en el suelo |
取扱説明書 |
Operating instructions |
Mode d’emploi |
Bedienungsanleitung |
Istruzioni per l’uso |
Gebruiksaanwijzing |
Manual de instrucciones |
10
En