Installation and assembly instructions
BWhen installing speakers below the plasma display or one body type plasma display
Use the long support legs.
Use the hexagonal wrench included with the stand to do so.
Long support legs |
Short hexagonal bolts |
(M8 ⋅ 16 mm: black) |
Long support |
legs |
Slide grooves |
into place |
PDPブbracketラケット |
| The types of plasma displays which may be used | |
| with the stand differ depending on the length of | |
Caution | the support legs attached to the PDP bracket, so | |
you should check to see if the display to be | ||
| ||
| attached is compatible before proceeding. |
4Attach plasma display to support legs.
Fit the stand’s support columns to the bottom of the plasma display as indicated by the arrows, then slowly insert them vertically. Be extremely careful not to insert the support legs of the stand into any part of the plasma display other than the stand insertion slots. Note that doing so might damage the plasma display panel or its ports or result in the warping of the stand. If the plasma display is fitted with handles, it is usually best to hold the display by its handles when attaching it to the support legs.
Line up the support legs with the bottom of the plasma display as indicated in the accompanying diagram.
Be sure to work with at least one other person when attaching the display.
Caution Be careful not to allow your fingers get caught between the display and support legs.
If the PDP bracket has been placed into the upper bracket holes and speakers are to be installed below the plasma display or one body type plasma display, care must be taken to ensure that the display is firmly supported as its position will be higher.
12
5Use the middle or the long hexagonal bolts to fix the plasma display to the support legs (4 locations).
Please install starting with the bolts on the top.
When installing the
Use the following bolts to fix it with the hexagonal wrench.
Top | Middle hexagonal bolts (M8 x 35 mm: black) |
Bottom | Middle hexagonal bolts (M8 x 35 mm: black) |
Middle hexagonal bolts |
(M8 x 35 mm: black) |
Middle hexagonal bolts |
(M8 x 35 mm: black) |
If speakers are to be installed at the sides or the bottom of the plasma display, they should be attached at this phase.
See the installation instructions provided with your speakers for instructions on how to install them.
When installing the one body type plasma display
Use the following bolts to fix it with the hexagonal wrench.
Top | Long hexagonal bolts (M8 x 60 mm: silver) |
Bottom | Middle hexagonal bolts (M8 x 35 mm: black) |
Long hexagonal bolts |
(M8 x 60 mm: silver) |
Middle hexagonal bolts |
(M8 x 35 mm: black) |
En