Installation and assembly instructions
10 Attach one support column cover to the center support column to cover cables, and fix it with screws (M4 x 10 mm: silver) (2 screws, on the top and bottom).
Pull the support column cover toward you slightly, then bend it around toward the back.
Support column cover
Be careful not to allow cables to become caught in the support column covers.
Caution
11 Follow the same procedure to attach the support column cover on the other side, and fix it with screws (M4 x 10 mm: silver) (2 screws, on the top and bottom).
12 Attach cap.
The side with the cutout portion is the rear side.
Cap
Moving the stand and display
When moving the stand and display, hold the stand by its center support column.
When moving the stand and display, never do so by holding the plasma display, speakers, or glass panel, as doing so might result in breakage or damage to the equipment.
When moving over an uneven surface of any kind, pick up the stand and display by the base of the stand.
Be careful when you place the stand and display on a thick carpeted surface, because when you do, the fibers may become entwined in the casters preventing them from rolling.
When moving the stand and display.
Depending on the type of surface on which the stand is placed, the casters may leave marks on the surface, and this should be taken into consideration when selecting the place in which the stand is to be placed.
Preventing equipment from falling over
After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.
1Attaching falling prevention bolts to the Plasma Display.
2Using strong cords or chains to stabilize it appropriately and firmly to a wall, pillar, or other sturdy element.
Perform this work in the same way on the left and right sides.
Note
Use falling prevention bolts, ropes, chains, and fittings that are available on the market.
Recommended hook:12 to 15 mm
Nominal diameter M8 Length 12 to 15 mm
13 Attach cable clamps.
The cable clamps may be used to bundle up any excess lengths of cable as shown in the diagram below.
Note
Be careful not to step on any cables when moving the stand.
Cable clamp |
14 |
En |
1Falling prevention
bolts
Fitting
2Cord or chain