Pioneer PDP-5020FD, PDP-6020FD

English

Introduction to the 20FD Series Flat Panel TVs

Operating Range for the Remote Control

To control the flat panel TV, point the remote towards the sensor on the panel’s bottom right corner. For easy

operation, keep the distance between the remote control and the sensor less than 7m (23 feet) and at an angle of

less than 30 degrees.

The remote control may not work properly if the sensor is in direct sunlight or very bright lighting. If your viewing

room is naturally bright, change the position of the panel or physically use the remote control closer to th e panel’s

sensor.

Note: If the remote control is left si tting in direct sunlight or under a very strong light, the case could warp or deform.

30º Sensor

30º 7 m

(23 feet)

PDP6020FD.book Page 11 Monday, March 17, 2008 10:51 AM

Contents

Main PIONEER CORPORATION Register Your Product on (Canada) http://www.pioneerelectronics.com (US) http://www.pioneerelectronics.ca http://www.pioneerelectronics.com http://www.pioneerelectronics.ca (Canada) Enregistrez votre appareil sur: (tats-Unis) *Voir et Entendre na jamais eu autant de sens IMPORTANT Wash hands after handling TABLE OF CONTENTS Page Page 1 Introduction to the 20FD Series Flat Panel TVs 1.1 Flat Panel TV Shipment Checklist Page 1.2 Control Options: Get to Know Your Flat Panel TV 1.2.1 Control Buttons and More on the Flat Panel TV 1 2 3 6 7 8 23 24 25 12114 13 14 15 16 17 18 19 20 21 9 10 225 1.2.2 Operating the Remote Control Page 1.2.3 Buttons on the Remote Control Page 2 Install Your Flat Panel TV 2.1 Choose a Location and the Mounting Method Page 2.2 Install the Panel Using a Stand 2.2.1 Use or Remove the Included Stand Refer to Attach/Detach the Speaker on page 18 for assistance. Page Page 2 ) Attach the center speaker bracket using the supplied screws. When fitting the screws, place screws 1 and 2 through the holes in the center bracket. 3 ) Position the speaker by the brackets. The drawing in the next Step shows the proper order for tightening screws. 4 ) Insert the speaker bracket into the grooves at the rear of the speaker. If the speaker fails to mount easily, adjust the angle of the brackets. Page Page 2.3 Wall/Ceiling Mounting Page 2.4 Mount the Flat Panel TV Page 2.5 Connect to Broadcast TV & Other Devices (DVR, Receiver, BDR, etc.) 2.5.1 Add Analog (conventional) and Digital TV Channels Connect cable or Satellite using STB (Set Top Box): 2.5.2 Connect Your Other Pioneer Equipment Connect HDMI equipment (INPUT 4 through INPUT 6): Connect HDMI equipment (INPUT 7): Connect a DVD player: Connect an AV receiver: Connect a VCR: Connect a game console or camcorder: Connect control cords: Connect a PC: 2.5.3 Connect the Power Cord to the Panel 2.6 Route then Bundle the Power Cord and Cables Bundle cables in small groups when possible for easier separation later, if necessary. Note: Avoid pinching or creating pressure points when routing or bundling cables. 2 3 Basic Operations For Television Viewing 3.1 Turn the Flat Panel TV ON/OFF ( Note: While in Standby, pressing the remote controls the remote control to turn on the panel 3.2 Program the Flat Panel TV for Television Viewing This chart provides a breakdown of the Home Menu for both AV and PC sources. 3.2.3 Assign a Language Use the arrow buttons to highlight an option then press Language 1 4 8 2 3 5 6 7 Page Page Page Page Page Page 3.3 Quick Start for Watching Television 3.3.1 Change the Channel/Sub-Channel Sleep Timer Note: To tune in a program more quickly, enter the channel or sub-channel then press 3.3.2 Adjust the Volume/Sound 3.4 Adjust the Picture and Sound Quality Page Page Page Page 3.5 Block Programs, Channels, or Content Page A block (B) or view (V) symbol appears in appropriate rating boxes. For other rating options, press to toggle between block and view. MPAA Ratings menu TV Parental Guidelines menu Unavailable Ratings menu Digital Regional Ratings menu Canadian English Ratings menu Canadian French Ratings menu Page Page 3.6 Smart Starts for New Owners Page 4 Additional Picture and Sound Adjustment Options 4.1 Choose an AV Option (Video, Game, etc.) When the screen disappears, the panel locks in last viewed option and the menu closes. 4.1.1 AV Source through the Remote Control The current AV selection appears. Pictur e AV Selection 4.1.3 Choose a PC Source 4.2 Adjust Specific Picture Elements Note: Not all broadcast programs carry alternative screen sizes. 4.2.2 Correct the Picture for an AV or PC Source Picture Note: Reset returns all settings to the factory defaults. AV Source PC Source 4.3 Assign Advanced Picture Functions Side Mask Brightness Sync. Text Opt imi zat ion Film Mode PureCin ema 4.4 View in Multi-Screen 2-Screen Picture-in-Picture (P-in-P) 4.4.1 Split/Swap/Shift the Screen 4.5 Freeze the Picture 4.6 Use the Banner Feature InfoBanner InfoBanner (additional) 4.7 Select Alternatives for/to Sound 4.7.1 Activate Closed Captioning (CC) Analog Settings Status Digital Settings Digital Service Digital Settings The default parameter for each option is Auto. 4.7.2 Switch Languages Using MTS MTS English, Franais MONO STEREO, SAP MTS Espaol. 4.7.3 Select SAP 4.8 Manage the Power Page 5 Use Other Equipment With Your Flat Panel TV 5.1 Program the Remote Control to Operate Other Equipment Page Page Page 5.1.7 Control a DVD Player/DVR Recorder/BD Player 5.2 Use HDMI Inputs Signal Type Press the 5.2.1 Specify the HDMI Input Type 5.2.2 Specify a Digital HDMI Signal Type Video 5.2.3 Specify an Audio HDMI Signal Type Audio HDMI Input 5.3 Control Equipment with the Panels Remote Through HDMI HDMI Control Use the arrow buttons to highlight an option then press Note: Pressing on the remote also causes the HDMI Control menu to open. HDMI Control Setting Input Setting 5.3.1 Control an AV System Page 5.3.4 Add an AV Amp or a BD Player To add an AV amp and/or a BD Player, refer to the appropriate cabling diagram below. AV Amp & B D Player BD Player only 5.4 Specific HDMI Control Commands 5.5 Connect a Game Console or Camcorder 5.6 Operate the Home Media Gallery Page Page Page Page 5.7 Run the Home Media Gallery Page 90 PDP6020FD.book Page 90 Monday, March 17, 2008 10:51 AM En Thumbnail screen Thumbnail List screen List screen (Sample screens) The Home Media Gallery menu appears on screen. HMG Playlist This menu can appear as a List, Thumbnail or Thumbnail List screen. Press Photo Movie, Music Note: This function may not be supported, depending on the content. Use the arrow buttons to highlight an option then press 5.7.2 Play Your Music Files on the Flat Panel TV to move from the Player screen to the previously selected screen has no effect. 5.7.3 Show Your Photo File on the Flat Panel TV , 5.8 Use the TOOLS Menu Page Page Page Page Page The TOOLS Menu appears on screen. Change View The movie (music) begins playing from the set time. To cancel the Time Search, press Start to The TOOLS Menu appears on screen. A Time Search dialog screen appears. Enter Hour and Minute for movie content or Minute and Second for music content. Use (if a numeric key icon appears). Press to select Hour and Minute (movie content) or Minute and Second (music content). Page Page Page Page Page 5.9 HMG Setup 5.10 Other useful functions Displaying pictures in the Home Media Gallery for an extended period may cause an after-image. 5.11 Add Other Audio Equipment 5.12 Add a Computer (PC) 6 Helpful Information 6.1 Frequently Asked Questions (FAQs) Why wont the remote control buttons control my flat panel TV? Why do I have to move closer to the panel to use the remote control? How can I protect the remote so it holds up longer? 6.2 Check Your Software/Hardware Version Software and hardware versions appear. 6.3 Cleaning Methods Note: Do not use liquid cleaners or aerosol cleaners on the screen. 6.4 Troubleshooting & Service Information ) on the remote control or If the panel indicator lights red, press ( on the flat panel TV. Clean the vents or remove any blocking objects. Page Page Page Page 6.4.1 Check the Signal Strength Digital Tuner Setup Installation RF Channel Signal Check To add the channel(s), select Add. 7 Cautions and Warnings 7.1 Installation Details 7.2 Physical Location & Temperature Considerations 7.3 Usage Guidelines 07 Cautions and Warnings 7.4 Signal Interference or Noise white noise video noise 7.5 Phosphor Properties Page 07 Cautions and Warnings 7.7 Safety Precautions 7.8 Legal Notices 7.8.1 Safety WARNING FEDERAL COMMUNICATIONS COMMISSION DECLARATION OF CONFORMITY 8 Appendix 8.1 Ratings Charts (for Various Audience Classifications) 8.1.3 MPAA Movie Ratings (age-based) 8.1.1 TV Ratings (age-based) 8.1.2 U.S. TV Parental Guideline Ratings (age/category-based) 8.1.4 Canadian - English Ratings (age-based) 8.1.5 Canadian - French Ratings (age-based) 8.2 Manufacturer Codes to Program into the Remote Control 8.2.1 Cable 8.2.2 Satellite 8.2.3 VCR (Brands A - F) 8.2.4 VCR (Brands G - O) 8.2.5 VCR (Brands P - V) 8.2.6 VCR (Brands W - Z) 8.2.7 PVR 8.2.8 BD (HD-DVD) 8.2.9 DVD-R Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code Brand/Code 8.2.10 DVD (Brands A - N) 8.2.11 DVD (Brands O - Z) 8.2.12 LD 8.3 Specifications Note: Design and specifications are subject to change without notice License Page Page Page Page Page Page Page Page Page Page Page Page Page Page 8.4 Glossary Page 8.5 Index Appendix 08 8.6 Trademarks, Licenses, & Patent Information Trademarks License Disclaimer Notice