Pioneer PDP-5020FD, PDP-6020FD 2.5 Connect to Broadcast TV & Other Devices (DVR, Receiver, BDR, etc.)

26
En
02 Install Your Flat Panel TV
2.5 Connect to Broadcast TV & Other Devices (DVR, Receiver, BDR, etc.)
The type of equipment attached to your flat panel TV determines which panel ports are used. The following
sections explain how to connect broadcast TV and playback equipment such as a DVD player, Surround Sound
system, video recorder, etc. to the panel. If your equipment is not listed, please refer to the operating instructions
that came with the device(s) for connection assistance.
2.5.1 Add Analog (conventional) and Digital TV Channels
Whether a TV station broadcasts in Analog or Digital, your flat panel TV shows the programs as long as the panel
is programmed to accept the signal. To program your panel for broadcast TV, select terminal ANT.
The ANT terminal accepts both analog and digital
broadcasts. Connect a VHF/UHF antenna and/or cable
TV to the panel’s rear ANT terminal, then press TV/DTV
on the remote control to toggle between analog and
digital broadcasts. When watching analog TV
channels, you can also use an outdoor antenna for the
clearest analog picture.
If your outdoor antenna uses a 75-ohm coaxial cable
with an F-type connector, plug it into the panel’s
antenna terminal on the back.
2.5.2 Connect Your Other Pioneer Equipment
This section provides cabling information for your other Pioneer equipment when combined with the panel. Each
diagram can also be used as a reference tool for non-Pioneer devices but port locations may differ or be unavailable.
Connect cable or Satellite using STB (Set Top Box):
T
W
T
W
In order to watch both analog and
digital broadcasts through your
terrestrial antenna or cable
connection, you must first connect the
antenna cable to a splitter.
Rear view
When using a cable STB or Satellite STB, plug in to the antenna/cable TV wall outlet using the STB cable provided
with your STB. If your STB has an HDMI terminal, use any of INPUT 4 through INPUT 6 (HDMI terminal) on the
rear or INPUT 7 (HDMI terminal) on the side of the flat panel TV instead of making video connections. If you
connect an antenna cable directly to TV, you must first connect the cable to a splitter. For details, refer to the
operating manual that came with the STB.
IN
HDMI OUT
OUT
AUDIO
OUT COMPONENT
VIDEO OUTPUT
Y
PB
PR
T
W
T
W
IN
HDMI OUT
OUT
AUDIO
OUT COMPONENT
VIDEO OUTPUT
Y
PB
PR
SAT IN
Rear view
Satellite antenna
Cable STB/Satellite STB Cable STB/Satellite STB
PDP6020FD.book Page 26 Monday, March 17, 2008 10:51 AM