18
En
02 Install Your Flat Panel TV
Attach/Detach the Speaker
The flat panel TV’s speaker delivers high-quality, clear sound. The left/right balance is enclosed in a single unit for
ease of installation and compactness. Although other devices can be added or removed from the mounted panel,
physically attach the speaker last. Disconnect the cables from the Speaker and REMOVE THE SPEAKER before
mounting or moving the panel.
Before attaching the speaker to your mounted panel, review the information below.
• Lay the panel face down on a stable surface when attaching speaker brackets.
• Use only the supplied screws and tighten securely before stepping away.
• The speaker is wide and requires more than a single person to manage.
• Handle the speaker carefully to protect the cabinet and grille net from scratches and other damage.
• Placing a CRT monitor near the speaker can cause a blur on the flat panel TV. Keep the distance between the
speaker and the monitor.
Note: Use the foam packing materials to protect the equipment from scratches or other damage during mounting.
Stand-Mounted Panel
It is possible to attach the speaker brackets to the flat panel TV while it is standing upright though it is easier to
mount the brackets while the panel is laying flat. Once the brackets are attached, stand the panel upright then
move it into the final position before mounting the speaker.
1 ) Attach the side speaker brackets (left and right) to the back of the panel using the supplied screws.
Connecting this speaker to another panel or device can
damage the unit or cause a fire.
When using tone control to increase treble, avoid over-
amplifying the volume.
When looking at the back of the flat panel TV, sides are reversed. Tighten screws in the order shown above.
Speaker mounting
screw (M5 x 10 mm)
1 )Tighten the screw in the
upper screw hole first.
2 )Then, tighten the screw in
the screw hole right under
the upper hole.
(PDP-6020FD) (PDP-5020FD)
Speaker bracket (side)
PDP6020FD.book Page 18 Monday, March 17, 2008 10:51 AM