70
En
05 Use Other Equipment With Your Flat Panel TV
5.1.3 Clear Added Manufacturer Codes from the Remote Control
To return all learned and preset codes to the defaults (PIONEER), follow the steps below.
1 ) Press EDIT and TV at the same time.
Selection can be in any mode.
2 ) Press the Yellow button.
Confirm that the selected mode indicator flashes.
The remote control enters the Manufacturing Reset mode. The reset is
complete when the mode indicator flashes on for one second. The
remote control then returns to normal operation.
Note: The panel’s remote control may not control or have complete control
of some equipment listed in the tables.
To exit before the reset is complete, press the EDIT button again. The reset is cancelled if no action is taken within
60 seconds. Also, switching the Mode during this procedure cancels the reset.
5.1.4 Control a Pioneer Receiver
The flat panel T V’s remote contr ol has a bank of butt ons specifically for controlling a Pioneer receiver. The active
buttons, left to right, are as follows:
• RECEIVER STANDBY/ON
(turns the Pioneer Receiver On/Off)
• RECEIVER INPUT
(cycles through/selects an input)
• RECEIVER VOL –
(adjusts the volume lower)
• RECEIVER VOL +
(adjusts the volume higher)
PDP6020FD.book Page 70 Monday, March 17, 2008 10:51 AM