22
En
02 Install Your Flat Panel TV
2.3 Wall/Ceiling Mounting
Lay the 50” panel down on a raised surface then remove the stand.
A common flat panel TV mounting option is to hang the panel on a sturdy wall or from a reinforced ceiling. When
mount ing i n this way, so me pr epara tion s must be co mpleted first. Follow the steps below to prepare the panel for
mounting.
1 ) Attach the speaker brackets but not the Speaker.
Refer to “Attach/Detach the Speaker” for instructions.
2 ) Connect the speaker cables to the panel if they are not already attached.
Connect the cables ONLY to the panel, not to the speaker.
3 ) Connect cables for any other devices to the panel.
When deciding on a location for your flat panel TV, consider other equipment in the room. Equipment such
as a DVR, Receiver, VCR, etc. requires some way to communicate with the panel, either directly or through
another device. Review the instructions that came with the other equipment for available ports and
terminals.
After deciding which ports and terminals are needed, mark the connections on the flat panel TV for easier
identification once the panel is mounted.
4 ) Temporarily bundle loose cables with rubber bands (not included).
5 ) Plug the flat panel TV’s power cord in to the panel but do NOT plug in to the power outlet.
6 ) Follow installation directions provided with your selected wall/ceiling mount.
Note: When attaching the speaker, refer to diagram in the following section regarding specific screw holes to use
for wall or ceiling mounting.
(PDP-5020FD)
Installation bolts (1)
Installation bolts (2)
(PDP-5020FD)
PDP6020FD.book Page 22 Monday, March 17, 2008 10:51 AM