20
En
02 Install Your Flat Panel TV
6 ) Attach the speaker to the side brackets using the supplied screws.
Note: If the speaker needs to be repositioned (horizontally or vertically) after it is attached, loosen the speaker
mounting screws first. Adjust the position then retighten the screws.
2.2.2 Connect the Speaker Cables
.
1 ) Press down on the tab.
2 ) Insert the appropriately colored wire into the opening.
3 )Allow a small percentage of the cable’s bare wire to remain visible.
4 ) Release the tab to clamp the wire.
If the bare wire is hidden when the tab is released, repeat Steps 1
through 4 until the proper amount of cable is showing.
5 ) Repeat this process for each cable, matching the color of the wire to the
appropriate terminal.
6 ) Connect the speaker cables to the speaker.
7 ) Bundle the speaker cables, power cord and other cables in the cable
clamp then insert the clamp into an appropriate hole on the rear of the
flat panel TV.
Refer to “2.6 Ro ute then Bundle the Power Cord and Cables.”
Use the clamps as necessary (see page 30).
➀➂➁
Speaker mounting
screw (M5 x 10 mm)
The bottom screw hole on each
speaker bracket is not used when
the panel remains on the stand.
tab
Gray
Speaker cable
Gray Black
Speaker terminal Black
Red Red
(PDP-6020FD)
PDP6020FD.book Page 20 Tuesday, March 18, 2008 6:15 PM