23
En
02
English
Install Your Flat Panel TV
Once your flat panel TV is mounted on the wall or suspended from the ceiling, follow the steps below to attach
the speaker.
1 ) Confirm that the speaker brackets are ready to support the speaker.
It is possible to jar the brackets out of alignment while installing the panel.
2 ) Connect the loose ends of the speaker cables to the speaker.
If the cables were bundled with rubber bands during installation, remove them before continuing.
3 ) Align the speaker with the brackets.
It is very easy to mount the speaker upside-down so confirm that the speaker is aligned properly before
continuing.
4 ) Insert the speaker brackets into the grooves at the rear of the speaker.
If the speaker fails to attach easily, adjust the angle of the brackets
5 ) Tighten the center screw then the side screws in the order shown above.
When installing the panel on a wall or ceiling, use the bottom screw holes on each speaker bracket.
Note: If the speaker needs to be repositioned (horizontally) after it is attached, loosen the speaker mounting
screws first. Adjust the position then retighten the screws.
➂
➀
➁
Speaker
mounting
screw
(M5 x 10 mm)
Do NOT use these holes when
mounting on a wall or ceiling Speaker
mounting
screw (M5 x 10 mm)
Speaker
mounting screw
(M5 x 10 mm)
•Insert the speaker from the bottom in an angle.
•Straighten it when it touches the speaker
bracket.
Note: Reverse procedure to remove the speaker.
PDP6020FD.book Page 23 Monday, March 17, 2008 10:51 AM