English
2Attach the speakers to the display.
Take care to ensure that the display does not hit the speakers in steps 1 and 2 when speakers are installed on the display.
1Place it below the display while inclining one speaker and insert it into the bracket on the right side.
2Similarly, insert the other speaker into the bracket on the
left side.
3Adjust so that the clearance between the speakers is lost and so that the speakers are not shifted to the right or left.
4Fix the two points in the center of the display with screws.
5Fix the two points (four points in all) on the right and left sides with screws. Adjust so that the speaker system is parallel to the display and then fix the speaker system.
NOTE:
÷When the display is to be moved after speaker installation, do not hold the display by the speakers. Hold the handle of the display and the side or bottom of the display with reference to the figures below when moving
the speaker system. Do not hold the speakers and raise the display. This may cause the deformation or damage of products.
When the speakers are installed | When the speakers are |
on the right and left sides | installed at the bottom |
CONNECTION TO A PLASMA DISPLAY
1Connecting the speaker cables
1Switch off the power of the plasma display.
2Connect the input terminals of the speaker system and the speaker output terminals of the plasma display with the accessory speaker cable. Make sure the positive (ª) and negative (·) terminals match when connecting.
1. Push the lever, insert the cable into the hole, and release the lever.
· terminal (black) ªterminal (red)
Input terminal of speaker
Red
Black
To the· terminal | To the ª terminal |
(Speaker input terminals of the speaker system)
2.For the output terminals on the plasma display, push the lever, insert the cable into the hole, and release the lever.
ª · · ª
Output terminal of plasma display
R L
÷After connection to the terminals, pull lightly on the cable to confirm that the tips of the cable are properly connected to the terminals. An imperfect connection can cause sound interruptions and noise.
÷When cable cores stick out and ª and · lines are short- circuited, an excessive load will be applied to the plasma display and the operation will stop or trouble will be caused.
÷When the polarity is reversed for one speaker (left or right) at the time of connection to the plasma display, the bass reproduction will be reduced, the sound positioning will be lost, and a correct stereo effect will not be obtained.
4
