Pioneer PDR-509 manual Connecting Up for Analog Playback & Recording, Supplied stereo, audio cords

CONTROL IN

CONTROL OUT

Connecting Up

Connecting Up for Analog Playback & Recording

Before you start, make sure that all the components are	recorder (check the instruction manual that came with your
switched off and disconnected from the wall outlet.	amplifier if you’re unsure about which terminals to use).
Next, connect this unit to your amplifier/receiver using the	Using this set up you can make recordings from any other
two sets of supplied audio leads—one set for playback,	component connected to the amplifier, via the analog
the other for recording. On the rear panel of your amplifier	inputs of this unit.
find an unused set of inputs/outputs for a tape/MD

PDR–509 CD-Recorder

AC IN

LINE IN LINE OUT CONTROL DIGITAL IN DIGITAL OUT

R	L	R	L	OPTICAL	COAXIAL	OPTICAL	COAXIAL
				IN

R L R L

Supplied stereo

audio cords To wall outlet.

Getting Set Up

R L R L

MD/TAPE

OUTPUT INPUT

REC PLAY

L

R

OUT

CONTROL

Pioneer ë out

Amplifier

Note: Rear panel show is that of U.S. and Canadian models; others may look slightly different.

Connecting Other Pioneer

ëComponents

If you are using a Pioneer amplifier or receiver that has this feature, you can control this unit with the multi- remote controller that came with your amplifier/receiver. The advantage of this is that you can use a single remote control to operate several components. Check the instruction manual that came with your amplifier or receiver for more information on using its remote as a multi-controller.

Use a commercially available cord with a mono mini- plug at either end to connect the

terminal of the amplifier/receiver to the terminal of this unit.

Make sure that at least one set of analog terminals is connected to the amplifier when using ë control cords.

11