Pioneer PDR-509 manual Troubleshooting, Additional Information

Additional Information

Troubleshooting

Below is a list of messages mainly related to playback and recording problems, together with a brief explanation and a page reference where you can find more information:

Display	Cause	Remedy	Reference
CHECK DISC	The disc is damaged or dirty.	Take out the disc and check for dust, dirt, scratches,	p.9
		etc. Clean as necessary.
	The disc is loaded upside down.	Take out the disc and reload it label-side up.	p.15
		If the same messages are displayed again after the
		disc is reloaded, unplug the power cord and plug it
		in again. If the same messages are still displayed,
		please contact a Pioneer authorized service center.
CHECK	A system error occurred, perhaps due	Unplug the power cord and plug it in again. If the
(blinking	to noise or static electricity.	same messages are displayed again, please contact
display)		a Pioneer authorized service center.
Display messages relating to recording:
Display	Cause	Remedy	Reference
CAN NOT	The input signal is digital-copy pro-	Record the source through the analog inputs.	p.25, 32
COPY	tected with SCMS.
CAN NOT REC	The digital source was interrupted.	Check that the digital input cable is connected	p10
		properly and that the power of the source player is on.
	The source is not audio, or is an	Check that the source is a regular music source.
	incompatible format (e.g. a CD–ROM).
CHECK INPUT	The source player was already playing	Stop the source player. After a short time, 1-SYNCor	pp.20–22
(CD) ?	when the DIGITAL SYNCHRO button was	AL-SYNCis displayed, and the recorder goes into
	pressed.	synchro–record-pause mode.
SET UP	The unit is preparing to record.	Wait until the message disappears.
REPAIR	The recorder was switched off/	While REPAIR is displayed, the recorder automatically
	unplugged after recording without	examines the recorded area of the disc and updates
	ejecting the disc. The recorder could	the track numbers and recording time data. This
	not write essential recording informa-	process takes about 40 minutes for a fully recorded
	tion onto the disc.	disc. Finalization or further recording is possible
		once the REPAIR message disappears.
RESUME	The unit is resuming an operation. If	Wait until the message disappears.	p.19
	the power supply is cut off (either by
	mistake or due to a power failure)
	during recording, the unit enters
	resume mode once power is restored
	so that additional recording is possible.
REC FULL	No more recording is possible because	Use another disc, or erase the CD–RWdisc.	p.19
	the available recording time of the disc
	has been used up, or 99 tracks have
	already been recorded on the disc.
Pro DISC	The loaded disc is a CD–Ror CD–RW	Load a CD–Ror CD–RWdisc that is designated as	p.8, 19
	disc for professional use without the	being for consumer use.
	CONSUMER USE disignation.
Display messages relating to playback:
Display	Cause	Remedy	Reference
NEW DISC	A blank disc is loaded.	Only recording is possible on blank CD–Ror CD–RW	p.19
		discs. Playback is not possible.
NO DISC	An attempt is made to start playback	Open the tray and check that a disc is loaded.	p.15
	without loading a disc.

Information Additional

37