Pioneer PRV-9200 operating instructions VCR Plus+ programming with the power off, US Code

Recording 06

1Press ‘VCR Plus+’ to display the VCR Plus+ program screen.

You can also access this screen from the Home Menu (press HOME MENU, select Timer Recording, then VCR Plus+).

VCR Plus+
PlusCode#		3 9 9 2 4	0	9 to input
Rec Mode	MN21		REC MODE to change
				to change level
Rec Times	Once	Daily Weekly		to change
Rec to	HDD		HDD	DVD to change

•Use the number buttons to enter the PlusCode number. (To clear the last digit entered, press CLEAR.)

•Press REC MODE to select FINE, SP, LP, EP or AUTO (See Recording time and picture quality on page 45). If Manual Recording is on, then you can also select the MN setting.

• Use the (cursor left/right) buttons to select the Once, Daily or Weekly recording option.

•Press HDD to record to the hard disk drive, or DVD to record to a DVD.

2After making the settings, press ENTER. The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited.

•If you haven’t set up the guide channels (or at least the guide channel for the PlusCode number that you entered), the recorder will prompt you to enter the channel number that the TV program is showing on.

Tip

•You can check the timer program settings by pressing TIMER REC to display the timer recording screen.

VCR Plus+ programming with the power off

You can enter a PlusCode number when the recorder is in standby. Note that the recording is always made to the HDD. If you want to record to a DVD disc, you’ll need to switch on the power and use the full VCR Plus+ program screen.

VCR Plus+

CLEAR

ENTER

Important

•You can’t use this feature until you have set up the guide channels. See VCR Plus+ CH Setting on page 97.

•You can’t change the recording mode.

•You can’t program daily or weekly timer recordings.

1 Press ‘VCR Plus+’.

The front panel display shows the current recording mode and prompts you to enter the PlusCode number.

P L US CODE

2Use the number buttons to enter the PlusCode number.

2 9 32 4

• To clear the last digit entered, press CLEAR.

3 Press ENTER.

The display shows the timer settings:

Date Start time End time HDD and Recording channel.

•If CODE ERROR appears in the display, check that the PlusCode number is correct and that the guide channel is set (see VCR Plus+ CH Setting on page 97), then set the timer recording again.

•If CAN’T SET appears in the display, it means that although you entered a valid PlusCode number, the program has already finished.

51

En