Pioneer XV-DV313, S-DV313 Other connections, Reducing the TV and line signal levels

Other connections 12

•Connect the TV (IN) jacks to the audio outs of your TV (or VCR).

This will enable you to hear the TV (or VCR) through this system. Connect using RCA pin- plug stereo cables. See also Reducing the TV and line signal levels below.

Tape deck, etc.

AUDIO	AUDIO
OUTPUT	INPUT

IN IN OUT

	FRONT	CENTER	SURROUND
EAKERS	6	6	6
L			L

TV AUDIO LINE 1

R R

6 6 6

SUB

WOOFER

XV-DV313

•Connect the LINE 1 (IN) jacks to the analog outputs of an external playback component.

These include components such as a VCR or cassette deck. Connect using RCA pin-plug stereo cables. See also Reducing the TV and line signal levels below.

•Connect the LINE 1 (OUT) jacks to the analog inputs of an external recording component.

These include components such as a cassette deck, VCR, MD or another recorder with analog inputs. Connect using RCA pin- plug stereo cables.

•Connect the LINE 2 (OPTICAL IN) jack on the rear panel to the optical digital output of an external playback component.

OPTICAL	IN
LINE 2

These include digital components such as an MD player, digital satellite, or a game system. Connect using a optical digital cable (not supplied).

Reducing the TV and line signal levels

• Default setting: ATT 6dB

Some sources may produce a high signal level which may produce unpleasant distortion from the speakers. In such cases, you may need to reduce the signal level of the auxiliary source (connected to the TV or LINE 1 analog inputs) by switching on the attenuator.

1Switch the system into standby.

2Press SYSTEM SETUP.

3 Use the (cursor left/right) buttons to select ‘TV ATT?’ or ‘LINE1 ATT?’, then press ENTER.

4 Use the (cursor up/down)

buttons to select ‘ATT Off’, ‘ATT 6dB’ or ‘ATT 10dB’.

If the ATT 6dB setting still results in distorted sound, try the ATT 10dB setting.

5 Press ENTER to confirm.

English Italiano Français Deutsch Nederlands Español

69

En