Controlling the rest of your system | 10 |
3If necessary, press the input function button for the component whose command you want to input.
This is only necessary if the command is for a new component (input function).
4Select the button for the command you want to input.
The LED blinks once and flashes continuously.
!You don’t need to program the receiver to
switch on or off. This is done automatically. With Pioneer components, you don’t need to program the power to switch off in a shutdown sequence (except DVD recorders).
5Repeat steps 3 to 4 to program a sequence of up to five commands.
If you press RCU SETUP before programming is completed, commands programmed up to that point will be stored.
6Press RCU SETUP to exit the programming mode.
Using multi operations
1 Press MULTI OPERATION.
Release the button after the LED flashes once. The LED continues to flash.
2Within five seconds, press an input
function button that has been set up with a multi operation.
The receiver switches on (if it was in standby) and the programmed multi operation is per- formed automatically.
Using System off
1 Press MULTI OPERATION.
Release the button after the LED flashes once. The LED continues to flash.
2Within five seconds, press uSOURCE. The command sequence you programmed will run, then all Pioneer components will switch
off, followed by this receiver (switch of all the zones becomes off).
!In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
Erasing the settings for the
This erases all the settings programmed in the remote control for the
1Press and hold RCU SETUP, then press ‘8’ for three seconds.
Release the button after the LED flashes once. The LED continues to flash.
!To cancel the preset setup mode press
RCU SETUP.
2Press the input function button containing the program you want to cancel or the uSOURCE button for three seconds.
If the LED lights for one second, the erasing has been successfully completed.
Resetting the remote control settings
Use this procedure to reset all the remote con- trol’s settings to the factory default.
!When preset codes are set, all the signals learned in the input function buttons are cleared. This function is convenient when you want to reset some but not all of input function buttons.
1Press and hold RCU SETUP, then press ‘0’ for three seconds.
Release the button after the LED flashes once. The LED continues to flash.
2Press and hold the ENTER button for three seconds.
If the LED lights for one second, the erasing has been successfully completed.
Default preset codes
Input function button | Preset code |
DVD | 2158 |
BD | 2160 |
DVR/BDR | 2150 |
HDMI | 2159 |
TV/SAT | 0116 |
CD | 5066 |
TV CTRL | 0116 |
En 57