Pioneer VSX-36TX Multi Channel In Setting, Use the 5´ buttons to select MULTI CHANNEL IN, Adjust

Initial Set Up

Multi Channel In Setting

If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, that is coming out of the decoder at full volume, or set to ADJUST, which means the levels can be reduced in volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.29) first.

ë￿	USE	SETUP
S0URCE		RECEIVER
MULTI	SYSTEM
OPERATION	OFF

DVD/LD TV/SAT VCR1 VCR2

MULTI CONTROL

1 Use the 5´° buttons to select MULTI

CHANNEL IN.

See “Setting Up for Surround Sound“ on page 29 if you need more information.

CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS

Press the ENTER button.

¦￿ 7 3 8

- TUNING +		- STATION +
1 Á￿ 4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2	3
4	5	6
7	8	9
GUIDE	0	EXIT
		ENTER
+10		DISC
+	TV	+
TV VOL	TV CONTROL	VOLUME
–	TV FUNC	–

REMOTE SETUP

This information will be displayed on your TV.

Multi channel in Select mode [Channel Level]

[BYPASS]

[EXIT]

INPUT	MENU	MUTE
ATT

CH SEL	+		2 Use the 2´3 buttons to select the setting
SYSTEM SETUP
EFFECT/		FUNCTION	you want, BYPASS or ADJUST.
	ENTER	1-3

DIGITAL	–		SIGNAL
NR			SELECT
MIDNIGHT	MULTI CH	DSP	STEREO/
	INPUT		DIRECT

/DTS

LIGHT THX ADVANCED STANDARD

ADJUST

Use the ADJUST setting when you want to be able to control each channel level individually.

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

BYPASS

This setting is good for getting the cleanest possible signal. In this setting you won’t be able to change each channel individually.

We recommend using BYPASS and the default setting is

BYPASS.

3 Use the 5´° buttons to select EXIT.

Press the ENTER button.

You wil return to the SYSTEM SETUP mode.

Multi Channel In Setting Using the Main Unit

You can also use the main unit to change the sound level of the MULTI CH IN. Follow the step below.

STANDBY/ON	MULTI CH INPUT
	NºmÀ²³õm

1Put receiver in the STANDBY mode.

2While holding down the MULTI CH

INPUT button press the

STANDBY/ON button.

The setting will change depending on what state the receiver was previously in. For a few seconds the display will show you which MULTI CH setting you are now in.

memo The default setting is BYPASS.

40