Pioneer VSX-36TX, VSX-37TX manual Setup Menu

Initial Set Up

Channel Delay

Adding a slight delay to some speakers is necessary to achieve a surround sound effect. You need to figure out the distance from your listening position to your speakers to add the proper delay. The following steps show you how to set the delay time for each channel by specifying the distances from your listening position to each speaker. Once you specify the speaker distances, the receiver calculates the correct delay times automatically. If continuing from Speaker Setting go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.29) first.

ë￿	USE	SETUP
S0URCE		RECEIVER
MULTI	SYSTEM
OPERATION	OFF

DVD/LD TV/SAT VCR1 VCR2

1Select CHANNEL DELAY (if continuing from last set up, it will already be selected).

	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING	+	- STATION +

1 Á￿ 4 ¢

DTV ON/OFF DTV MENU - CHANNEL +

See “Setting Up for Surround Sound“ on page 29 if you are unsure how to do this.

Press the ENTER button.

1	2	3
4	5	6
7	8	9
GUIDE	0	EXIT
		ENTER
+10		DISC
+	TV	+
TV VOL	TV CONTROL	VOLUME
–	TV FUNC	–
REMOTE SETUP
INPUT	MENU	MUTE
ATT
SYSTEM SETUP
EFFECT/	+	FUNCTION
CH SEL

Channel Delay				[10.0ft]
Front	L
Center				[10.0ft]
Front				[10.0ft]
	R
Surround				[10.0ft]
			R
Surr Back				[10.0ft]
			R
Surr Back				[10.0ft]
		L
Surround				[10.0ft]
			L
Subwoofer				[10.0ft]
[EXIT]

• The default setting is 10 ft.

	ENTER			1-3	2 Use the 5´° buttons to select a speaker.
NR	–		SELECT
DIGITAL			SIGNAL		Specify the distance from your listening
	INPUT		DIRECT
MIDNIGHT	MULTI CH	DSP	STEREO/
		/DTS			position to each speaker using the
LIGHT	THX	ADVANCED	STANDARD

commands below.

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

1Pres 2 or 3 to adjust the speaker distance in half foot increments from 0.5 to 45 feet.

The default setting is 10 feet.

2Use the 5´° buttons to move to the next set of speakers.

3 Repeat for each speaker.

• Sound takes about 1 millisecond to travel 1 foot.

3Select EXIT with the 5´° buttons and press

ENTER button to return to the SYSTEM

SETUP MENU.

Next, proceed to CHANNEL LEVEL on the next page.

If you want to change a setting before proceeding simply

use the arrow buttons to go back.

34