Pioneer VSX-37TX, VSX-36TX manual Channel Level, Select a Test Tone mode, Tone will be output

Initial Set Up

Channel Level

The following steps show you how to balance the sound output level of your speakers. Proper speaker balance is essential for obtaining high quality surround sound. If continuing from Channel Delay go to step 1. If starting fresh, complete steps 1-3 in “Setting Up for Surround Sound“ (p.29) first.

ë￿		USE	SETUP
S0URCE			RECEIVER
	MULTI	SYSTEM
	OPERATION	OFF
DVD/LD	TV/SAT	VCR1	VCR2
	MULTI CONTROL
CD	MD/	TUNER	TVCONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿ 4 ¢
DTV ON/OFF	DTV MENU	- CHANNEL +
1	2		3
4	5		6
7	8		9
GUIDE	0		EXIT
			ENTER
+10			DISC

1 Select CHANNEL LEVEL (if continuing from CHANNEL DELAY, it will already be selected).

See “Setting Up for Surround Sound“ on page 29 if you are unsure how to do this.

Press the ENTER button.

Channel Level

Test Tone [ AUTO ]

[Setting Start	]
[EXIT]

+	TV	+	NOTE : Be prepared! The test tone is output at a high
TV VOL	TV CONTROL	VOLUME	volume level.
–	TV FUNC	–

ATT	MENU	MUTE	2 Select a TEST TONE mode.
REMOTE SETUP
INPUT
SYSTEM SETUP	+		1 Press 2 or 3 to move the hand to AUTO or MANUAL.
CH SEL		FUNCTION
EFFECT/			2 Press ° button to select SETTING START.
	ENTER	1-3
DIGITAL	–	SIGNAL
NR		SELECT	AUTO (automatic TEST TONE)

SET UP

MIDNIGHT	MULTI CH	DSP	STEREO/
	INPUT		DIRECT

/DTS

LIGHT THX ADVANCED STANDARD

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

This mode switches the test tone between each speaker automatically. Use this mode when balancing the speaker levels by ear.

The automatic test tone is output in the following order:

FL CT FR

SW SL SBL SBR SR

MANUAL (manual TEST TONE)

This mode lets you switch the test tone between each speaker manually. You can use this mode when you want to balance the speaker levels by ear at a more leisurely pace.

memo

A test tone will be output from the SURROUND BACK speakers but your external amplifier must be turned up at least a little in order to hear it. Be careful that it is not turned up too much because the test tone volume is quite loud.

3After selecting SETTING START with the ° button press ENTER button. The TEST

TONE will be output.

These settings will be displayed on your TV.

Channel Level							SIGNAL		STEREO	VOLUME
Test Tone				[ AUTO ]			SELECT		A
							ANALOG	SP		dB
[	Setting OK				]		AUTO
				[		]
Front		L			0.0dB
Center				[	0.0dB]
Front				[ 0.0dB]
		R
Surround				[ 0.0dB]
			R
Surr Back			R	[ 0.0dB]
Surr Back				[ 0.0dB]
			L
Surround				[ 0.0dB]
			L
Subwoofer				[ 0.0dB]

It takes a moment for the machine to set itself. MASTER
VOLUME rotates to the reference position (0 dB), and the test
tone is output.
To exit before outputting the TEST TONE
Press the ENTER button.
To exit while outputting the TEST TONE	35
Press the ENTER button.