07The System Setup menu
You only need to do this if you didn’t connect your digital components according to the defaults above. This tells the receiver what component is connected to which terminal so it corresponds to the buttons on the remote.
1Select ‘IN ASSIG.’ from the System Setup menu.
2 | Use | to select ‘DIG.IN’ then press |
ENTER. |
| |
3 | Use | to select the number of the |
digital input to which you’ve connected your digital component.
The numbers correspond with the numbers beside the inputs on the back of the receiver.
4Select the component that corresponds with the one you connected to that input.
• Use the buttons and ENTER to select
DVD, TV, CD, CDR, DVR or OFF.
•If you assign a digital input to a certain function (for example, DVD) then any digital inputs previously assigned to that function will automatically be switched off.
5 Press RETURN when you’re finished.
The Other setup menu
The Other menu is where you can make customized settings to reflect how you are using the receiver.
1Select OTHER from the System Setup menu.
2 Use to select the setting you want to adjust then press ENTER.
If you are doing this for the first time, you may want to adjust these settings in order:
•DRC – Specify the amount of dynamic range adjustment to Dolby Digital soundtracks (see Dynamic Range Control Setup below).
•DUAL MONO – Isolate one channel when listening to discs with dual mono encoding (see Dual Mono Setup below).
•LFE ATT – Set the attenuator level for the LFE channel (LFE Attenuator Setup below).
3 Use to make the adjustments necessary for each setting, pressing RETURN to confirm after each screen.
Dynamic Range Control Setup
• Default setting: OFF
Specifies the amount of dynamic range adjustment to Dolby Digital or DTS soundtracks:
•MAX – Dynamic range is reduced (loud sounds are reduced in volume while quieter sounds are increased).
•MID – Mid setting.
•OFF – No dynamic range adjustment (use when listening at higher volume).
Dual Mono Setup
• Default setting: CH1
Specifies how dual mono encoded Dolby Digital soundtracks should be played:1
•CH2 – Only channel 2 is played
•CH1 CH2 – Both channels are played through the front speakers
•CH1 – Only channel 1 is played
LFE Attenuator Setup
• Default setting: LFEATT 0 dB
Set the LFE attenuator as necessary to prevent
•LFEATT 0 – No limiting (recommended setting)
•LFEATT 10 – 10 dB of limiting
•LFEATT ** – No sound from LFE channel
Note
1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.
40
En
