Connecting up | 03 |
1Connect the component video outputs of your source to a set of component video inputs on this receiver.
Use a
2If necessary, assign the component video inputs to the input source you've connected. This only needs to be done if you didn’t connect according to the following defaults:
•COMP 1 – DVD
•COMP 2 – TV
•COMP 3 – DVR
See Assigning the component video inputs on page 30.
3Connect the COMPONENT VIDEO MONITOR OUT jacks on this receiver to the component video inputs on your TV or monitor.
Use a
Connecting antennas
Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality, connect external antennas (see Using external antennas below).
fig. a fig. bfig. c
3
FM UNBAL
5 | 75 Ω |
|
| AM | 4 |
| LOOP | |
|
|
1
2 |
1Pull off the protective shields of both AM antenna wires.
2Push open the tabs, then insert one wire fully into each terminal, then release the tabs to secure the AM antenna wires.
3Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the stand (fig. b).
•If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. c) before clipping the loop to the stand. Make sure the reception is clear.
4Place the AM antenna on a flat surface and in a direction giving the best reception.
5Connect the FM wire antenna in the same way as the AM loop antenna.
For best results, extend the FM antenna fully and fix to a wall or door frame. Don’t drape loosely or leave coiled up.
Using external antennas
To improve FM reception
Use an F connector to connect an external FM antenna.
FM UNBAL 75 Ω
F connector
AM
LOOP
To improve AM reception
Connect a 5 m to 6 m (15 ft. to 18 ft.) length of
Outdoor antenna
5 m to 6 m
(15 ft. to 18 ft.)
Indoor antenna
FM UNBAL(vinyl-coated wire)
75
AM
LOOP
For the best possible reception, suspend horizontally outdoors.
English Deutsch Français Italiano Nederlands Español
13
En
