09Additional information

Switching the speaker impedance

We recommend using speakers of 8 with this system, but it is possible to switch the imped- ance setting if you plan to use speakers with a 6 impedance rating.

With the receiver in standby, press

STANDBY/ON while holding down the QUICK SETUP button.

Each time you do this, you switch between the impedance settings:

SP 6 OHM – Use this setting if your speakers are rated at 6 .

SP 8 OHM – Use this setting if your speakers are rated at 8 or more.

Specifications

Amplifier section

Continuous power output (stereo)

Front . .110 W (20 Hz to 20 kHz, THD 0.2 %, 8 )1

Rated power output

(surround / 20 Hz to 20 kHz, THD 0.07 %, 8 )

Front . . . . . . . . . . . . . . . . . . . . . .90 W per channel Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 90 W Surround. . . . . . . . . . . . . . . . . . .90 W per channel

Rated power output

(surround / 1 kHz, THD 1 %, 8 )

Front . . . . . . . . . . . . . . . . . . . . .120 W per channel Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120 W Surround. . . . . . . . . . . . . . . . . .120 W per channel

Power cord caution

Audio section

Input (Sensitivity/Impedance)

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or an electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. Check the power cord once in a while. When you find it damaged, ask your nearest Pioneer authorized service center or your dealer for a replacement.

CD, DVR/VCR, CD-R/TAPE/MD,

DVD/LD, TV/SAT. . . . . . . . . . . . . . . .200 mV/47 k

Frequency response

CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,

TV/SAT. . . . . . . . . . . . . . . 5 Hz to 100 000 Hz dB

Output (Level/Impedance) DVR/VCR REC, CD-R/TAPE/

MD REC . . . . . . . . . . . . . . . . . . . . . 200 mV/2.2 k

Tone control

Bass . . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (100 Hz) Treble . . . . . . . . . . . . . . . . . . . . . . ± 6 dB (10 kHz) Loudness . . . . . . +10 dB/+5 dB (100 Hz/10 kHz)

(at volume level –50 dB)

Signal-to-Noise Ratio (IHF, short circuited, A network)

CD, DVR/VCR, CD-R/TAPE/MD,

DVD/LD, TV/SAT. . . . . . . . . . . . . . . . . . . . . . .96 dB

Signal-to Noise Ratio [EIA, at 1 W (1 kHz)] CD, DVR/VCR, CD-R/TAPE/MD,

DVD/LD, TV/SAT. . . . . . . . . . . . . . . . . . . . . . .79 dB

Note

1Continuous average power output of 110 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.2 %** total harmonic distortion (front).

* Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers.

**Measured by Audio Spectrum Analyzer.

36

En

Page 36
Image 36
Pioneer XRE3138-A Specifications, Power cord caution, Switching the speaker impedance, Amplifier section, Audio section