The System Setup menu | 06 |
•If you connect any source component to the receiver using a component video input, you should also have your TV connected to this receiver's COMPONENT VIDEO MONITOR OUT jacks.
The Other setup menu
The Other menu is where you can make customized settings to reflect how you are using the receiver.
1Select OTHER from the System Setup menu.
2Use / to select the setting you want to adjust then press ENTER.
If you are doing this for the first time, you may want to adjust these settings in order:
•DRC – Specify the amount of dynamic range adjustment to Dolby Digital soundtracks (see Dynamic Range Control Setup below).
•DUALMONO – Isolate one channel when listening to discs with dual mono encoding (see Dual Mono Setup below).
•LFE ATT – Set the attenuator level for the LFE channel (LFE Attenuator Setup below).
3Use / to make the adjustments necessary for each setting, pressing RETURN to confirm after each screen.
Dual Mono Setup
•Default setting: CH1
Specifies how dual mono encoded Dolby Digital soundtracks should be played:1
•CH1 – Only channel 1 is played
•CH2 – Only channel 2 is played
•CH1 CH2 – Both channels are played through the front speakers
LFE Attenuator Setup
• Default setting: ATT 0 dB
Set the LFE attenuator as necessary to prevent
•LFEATT 0 – No limiting (recommended setting)
•LFEATT 10 – 10dB of limiting
•LFEATT ** – No sound from LFE channel
English Deutsch Français Italiano Nederlands Español
Dynamic Range Control Setup
• Default setting: OFF
Specifies the amount of dynamic range adjustment to Dolby Digital or DTS soundtracks:
•DRC OFF – No dynamic range adjustment (use when listening at higher volume).
•DRC MAX – Dynamic range is reduced (loud sounds are reduced in volume while quieter sounds are increased).
•DRC MID – Mid setting.
Note
1 This setting works only with dual mono encoded Dolby Digital and DTS soundtracks.
31
En