DLP® Projector – User’s Manual
LED Error Messages
Error code message | Power | Ready |
| LED/flashes | LED/flashes |
|
|
|
Over temperature | 3 | 0 |
|
|
|
Thermal Break | 4 | 0 |
|
|
|
G794 fail | 4 | 4 |
|
|
|
T1 fail | 4 | 5 |
|
|
|
Lamp error | 5 | 0 |
|
|
|
Ballast Over Temperature | 5 | 1 |
|
|
|
Ballast short circuit in output detected | 5 | 2 |
|
|
|
End of lamp lift detected | 5 | 3 |
|
|
|
Ballast lamp did not ignite | 5 | 4 |
|
|
|
Lamp extinguished during normal operation | 5 | 5 |
|
|
|
Lamp extinguished during | 5 | 6 |
|
|
|
Fan1 error (Lamp Fan) | 6 | 1 |
|
|
|
Fan2 error (Ballast Fan) | 6 | 2 |
|
|
|
Fan3 error (Burner Fan) | 6 | 3 |
|
|
|
Fan4 error (Power Fan) | 6 | 4 |
|
|
|
Lamp door open | 7 | 0 |
|
|
|
DMD error | 8 | 0 |
|
|
|
Color wheel error | 9 | 0 |
|
|
|
Image Problems
Problem: No image appears on the screen
1.Verify the settings on your notebook or desktop PC.
2.Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1.Adjust the Focus on the projector.
2.Press the Auto button on the remote control or projector.
3.Ensure the
4.Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.Position the projector so it is as perpendicular to the screen as possible.
2.Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed or upside down
Check the Projection setting on the Utility menu of the OSD.
Problem: The image is streaked
1.Set the Frequency and Tracking settings on the Utility menu of the OSD to the default settings.
– 42 –
