sdlc role – establish role of the interface
sdlc-largest-frame- Set the largest I-frame size that can be sent or received by the designated SDLC station
sdlc simultaneous [full-datemode half-datamode] - full-datemode is enable the primary station to send data to and receive data from the polled secondary station. half-datamode is Prohibit the primary stations from sending data to the polled secondary station.
sdlc t1 - Control the amount of time the Cisco IOS software waits for a reply sdlc vmac – configure a MAC for the serial interface.
sdlc dlsw – enable DLSw on an SDLC interface
sdlc xid - Specify the XID value to be associated with the SDLC station
sdlc poll-limit-value– configure the number of times router can poll a secondary station time
sdlc poll-pause-timer– configure the time that router pause between sending each poll frame to secondary station
sdlc poll-wait-timeout- specify the interval the router will wait for polls from a primary node before timing out that connection.
sdlc rnr-limit– configure the time that router allows its adjacent linkstation to remain in a busy (RNR) state before declaring it inoperative
sdlc slow-poll– enable the slow-poll capability of the router as a primary SDLC station sdlc t2 – configure the pool time
Figure 6-1 sna configuration example
400.1020.1000
| Token- |
| ring |
| 500 |
IBM host | FEP |
ROUTE A | ROUTE B |
| PU type 2.0 |
| sdlc address |
| 01 |
Configuration for Router A: