4.4.3.1 Set port [n]
This command allows configuring per port parameters of GSW-2416SF. the correct usage is shown as below: Set port [n]: n=1-24, to configuring per port parameters of GSW-2416SF.
Default setting: (1) Auto Speed
The configuring per port parameters screen in Figure 4-18appears and the detail description shown in table 4-2.
| | | | Figure 4-18Port Configuration screen |
| | |
Object | | Description |
| | | |
(1) | Auto Speed | Setup Auto negotiation of each port. |
(2) | 10 | Half | Force sets 10Mbps/Half-Duplex mode for specific port. |
(3) | 10 | Full | Force sets 10Mbps/Full-Duplex mode for specific port. |
(4) | 100 | Half | Force sets 100Mbps/Half-Duplex mode for specific port. |
(5) | 100 | Full | Force sets 100Mbps/Full-Duplex mode for specific port. |
(6) | 1000 Full | Force sets 10000Mbps/Full-Duplex mode for specific port. |
(7) | Disable | Disable or Shutdown the specific port |
Table 4-2Descriptions of the Port Configuration screen Objects
4.4.3.2 Set vlan [n]
This command allows configuring up to 24-port based VLAN Groups of GSW-2416SF. The correct usage is shown as below:
Set vlan [n]: n=1-24, to configuring 24 VLAN Groups of GSW-2416SF. [n] is the VLAN Group ID. And the following message appears:
Please input port number (1-24), exit press enters: Add/Remove port to the current VLAN Group, “*” means port had been assign to the VLAN Group.
Default setting: none
The configuring VLAN Groups screen in Figure 4-19appears. (Assign port 1, port 6 and port 7 to VLAN Group 1)