4.1.3 System Properties
Device Name | You may assign any name to the |
| helpful especially if you are employing multiple access points on the same |
| network. The device name needs to be less than 32 characters. After verify |
| the name you input and click “Apply” to save the setting. |
|
|
Country / Region | Here you can set the |
| regulations. |
|
|
Operation Mode | The default operation mode is Access Point; this mode connects your |
| wireless clients to a wired network. In most cases, no change is necessary. |
| You can switch operation mode to Wireless Client, Repeater or Wireless |
| Bridge mode depends on your application. Wireless Client mode can allow |
| AP act as a client within its range. Your Ethernet devices behind the AP client |
| can connect to a remote AP. Repeater is able to retransmit the signal of a |
| remote AP. Choose repeater mode if you want to extend the range of your |
| original AP. Wireless Bridge mode allow you to create a wireless connection |
| to connect the networks between different building. You may check to the |
| section 4.2/4.3 and 4.4 for more details of those operating mode. |
|
|
