Planet Technology WAP-6100 user manual Hardware Installation

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WAP-6100.

1.Locate an optimum location and use the provided metal ring to secure WAP-6100 to a mast.

2.Using provided CAT5 waterproof cable; connect the waterproof connector port of the WAP-6100 to the “P+DATA OUT” port of PoE Injector.

3.Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the management station to a hub or switch on the same LAN.

4.Connect the power cord to the PoE Injector, and plug it into an AC outlet to power up the WAP-6100.

Note: ONLY use the power adapter supplied with the WAP-6100. Otherwise, the product may be damaged.