Planet Technology WAP-6100

WPA security mode. Once you setup the AP to work in security mode, all wireless stations will also need

to have corresponding settings. System default setting is “No Security”.

WEP

Authentication type Select the appropriate value - "Open System" or "Shared Key". All Wireless

stations must then be set to use the same method.

Contents

Main Copyright FCC Caution: Federal Communication Commission (FCC) Radiation Exposure Statement CE Mark Warning Protection requirements for health and safety Article 3.1a Page TABLE OF CONTENTS Page Chapter 1 Introduction 1.5 Wireless Performance Page Chapter 2 Hardware Installation ! IMPORTANT SAFETY PRECAUTIONS: Page Chapter 3 Initial Setup 3.1 Setup Procedures Page Chapter 4 Web Configuration 4.1 Access Point Mode 4.1.1 System Summary Page 4.1.3 System Properties 4.1.4 Administration 4.1.5 IP Settings 4.1.6 Wireless Network 4.1.7 Wireless Security Page Page Page 4.1.8 Wireless Advanced Settings Page Page Page 4.2 Wireless Client Mode 4.2.2 Wireless Network 4.2.3 Wireless Security 4.3 Repeater Mode 4.3.1 Wireless Network 4.3.2 Wireless Security 4.4 Wireless Bridge Page Appendix A Glossary