Planet Technology WAP-6100 4.2 Wireless Client Mode

4.2 Wireless Client Mode

WAP-6100 can also work as an Ethernet client bridge to connect up to 16 Ethernet device into wireless

network. In order to setup the WAP-6100 to work in Ethernet bridge mode, you need to choose “Wireless

Client” mode and click “Apply” at System Properties page. You also need to reboot the WAP-6100. After

the system reboot is done, you can see the page as below. Status page shows the WAP-6100 is now

working in Wireless Client mode.

4.2.1 Connection Status

Contents

Main Copyright FCC Caution: Federal Communication Commission (FCC) Radiation Exposure Statement CE Mark Warning Protection requirements for health and safety Article 3.1a Page TABLE OF CONTENTS Page Chapter 1 Introduction 1.5 Wireless Performance Page Chapter 2 Hardware Installation ! IMPORTANT SAFETY PRECAUTIONS: Page Chapter 3 Initial Setup 3.1 Setup Procedures Page Chapter 4 Web Configuration 4.1 Access Point Mode 4.1.1 System Summary Page 4.1.3 System Properties 4.1.4 Administration 4.1.5 IP Settings 4.1.6 Wireless Network 4.1.7 Wireless Security Page Page Page 4.1.8 Wireless Advanced Settings Page Page Page 4.2 Wireless Client Mode 4.2.2 Wireless Network 4.2.3 Wireless Security 4.3 Repeater Mode 4.3.1 Wireless Network 4.3.2 Wireless Security 4.4 Wireless Bridge Page Appendix A Glossary