Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WRT-414.

2.1 Hardware Connection

 

12V DC

 

 

 

 

 

RESET

+

4

3

2

1

ANT

 

WAN

1.Locate an optimum location for the WRT-414.The best place for your WRT-414 is usually at the center of your wireless network, with line of sight to all of your mobile stations.

2.Adjust the antennas of WRT-414.Try to adjust them to a position that can best cover your wireless network. The antenna’s position will enhance the receiving sensitivity.

3.Connect RJ-45 cable to WRT-414 LAN port. Connect one of the LAN ports on WRT-414 to your LAN switch/hub or a computer with a RJ-45 cable.

4.Connect RJ-45 cable to WRT-414 WAN port. Connect xDSL/Cable Modem to the WAN port on WRT-414. Usually, this cable would be provided with your modem. If no cable was supplied with your modem, please use a RJ-45 Ethernet cable

5.Plug in power adapter and connect to power source. After power on, WRT-414 will start to operate.

Note: ONLY use the power adapter supplied with the WRT-414. Otherwise, the product may be damaged.

If you want to reset WRT-414 to default settings, press and hold the Reset button over 5 seconds and release. And then wait for WRT-414 restart.

Reset Button

This button has two functions:

 

To Reboot machine without Clearing Existing Configurations:

 

Press the reset button with a pencil tip (for less than 5 seconds),

 

machine will re-boot itself, the existing configurations will be kept.

 

To Clear All Data and restore the factory default values:

 

Press the reset button for longer than 5 seconds and the router will

 

reset itself to the factory default settings (warning: your original

 

configurations will be replaced with the factory default settings)

 

 

- 3 -