ØFlow control: none
After finished the setting, click OK.
2.2 Rear Panel
The Rear Panel of the switch is indicates an AC 3 pronged power socket and Ventilation fan. This switch will work with AC in the range
Figure
For the compatibility with electric service in most of areas,
Connect the power cord to the power socket on the Rear Panel of the Switch. The other side of power cord connects to the power outlet.
2.3 Hardware installation
For desktop installation, make sure the desk is flat and clean. Plug all the network cables and the power cord then the system is ready.
Note: Do not obstruct any vents at the sides of the case and keep water off.
1.Disconnect all cables from the switch.
2.Place the unit the right way up on a hard, flat surface with the front facing toward you.
3.Locate a mounting bracket over the mounting holes on one side of the unit.
4.Insert the screws and fully tighten with a suitable screwdriver.
5.Repeat the two previous steps for the other side of the unit.
6.Insert the unit into the 19" rack and secure with suitable screws (not provided).
7.Reconnect all cables.
5