Sync Flood

Protection the router from Sync Flood attack. If

 

you go to the advanced setting page, you can

 

configure the threshold of the frequency of

 

packets occurred.

Click <Save> at the bottom of the screen to save the above configurations and press “Apply and Reboot” to apply the configuration and reboot the XRT-D router. You can now configure other advance sections or start using the router (with the advance settings in place).

3.5.4 DMZ

If you have a local client PC that cannot run an Internet application (e.g. Games) properly from behind the NAT firewall, then you can open the client up to unrestricted two-way Internet access by defining a DMZ Host. The DMZ function allows you to re-direct all packets going to your WAN port IP address to a particular IP address in your LAN. The difference between the virtual server and the DMZ function is that the virtual server re-directs a particular service/Internet application (e.g. FTP, websites) to a particular LAN client/server, whereas DMZ re-directs all packets (regardless of services) going to your WAN IP address to a particular LAN client/server.

?DMZ function works only when the NAT function is enabled.

Note:

Parameters

Description

Enable DMZ

Enable/disable DMZ

 

Note: If there is a conflict between the Virtual Server and the

 

DMZ setting, then Virtual Server function will have priority over

 

the DMZ function.

WAN Port

The WAN port that the local client PC IP will bind to.

 

 

 

49