6.Carefully trim headliner from the dome light area toward the front of vehicle as shown. See figure 4.
Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated.
FIGURE 4
7.Install the mounting bracket in the O.E.M. dome light area. Align the front mounting tabs with the openings in the metal inner roof. Slide bracket rearward until flange contacts rear edge of recessed area. See Fig. 5.
FIGURE 5
8.Secure bracket to sheet metal frame using (4) four
#8 x 3/4" TEK screws. See Figure 6.
FIGURE 6
4
