19.Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The
suggested routing of the video system cable is as follows: Above the headliner from rear A/C switch opening to
20.Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in the console and video system. Connect the white wires from lights to the O.E. white wire. Connect the black wires from lights to the O.E. orange wires. Do not use O.E. black wire. See Figure 13.
on console
Caution: Do notFIGUREovertighten12 screws. Use extra support for the console until
secured to the vehicle. Failure to do so may cause damage to console or installed components.
21. Raise console into approximate position and connect wiring to O.E. components.
22. Loosely fit console against headliner. Check that console is centered in vehicle and matches all contours of headliner. While supporting console in mounting position, loosely install using two (2)
FIGURE 13
into threaded clips on mounting bracket. See Figure 14.
23.Carefully position console against headliner. Secure the front of console to the inner roof of vehicle using (2) two # 8 x 1 1/4" screws. Make sure console is centered between sun visors before tightening screws completely. See Figure 16. Tighten (2)
FIGURE 14
24. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing.
7
